Understanding the Legend dfe-530tx PCI Fast Ethernet Adapter
Your Legend dfe-530tx PCI Fast Ethernet Adapter, also known as the Legend dfe-530tx pci fast ethernet adapter (rev b), is a device that has been known to present some challenges when it comes to driver installation, especially on Linux systems. Let’s delve into the specifics of this adapter and how you can manage it effectively.
Driver Installation on Windows Server 2000
When dealing with the Legend dfe-530tx in a Windows Server 2000 environment, you may find that the system does not automatically recognize the adapter. This is not uncommon, and the solution lies in manually installing the drivers. You will need the driver disk that came with the adapter to proceed with this process. This ensures that the hardware is properly integrated into the operating system and can function as expected.
Identifying the Adapter in Linux
In Linux, the Legend dfe-530tx is often identified as eth0. If you see “eth0: unknown” during the boot process, it indicates that the Linux kernel has not recognized the driver for your network interface. This is a clear sign that you need to install the appropriate driver to get your network up and running.
Boot Parameters for the Legend dfe-530tx
When configuring the boot parameters for your Legend dfe-530tx, you mentioned that the adapter is using IRQ9 and an I/O range of D800 to D8FF. If you’re setting up the boot command as “boot: linux ether9,0x300,eth0,” you’re on the right track. However, if you’re considering changing the I/O range to “0x800,” it’s important to note that this is not correct. The I/O range should remain at D800 to D8FF as per the hardware specifications.
Network Configuration in Linux
Now, let’s move on to the network configuration. You’ve provided the following details for your local network:
| Setting | Value |
|---|---|
| IP Address | 10.1.1.47 |
| Gateway | 10.1.1.1 |
| Subnet Mask | 255.255.255.0 |
| DNS Server | 202.96.14.1 |
Here’s how you can configure these settings in Linux:
- Open the terminal.
- Use the command “sudo nano /etc/network/interfaces” to edit the network configuration file.
- Enter the following lines into the file:
auto eth0iface eth0 inet staticaddress 10.1.1.47netmask 255.255.255.0gateway 10.1.1.1dns-nameservers 202.96.14.1
- Save the file and exit the editor.
- Restart your network interface with the command “sudo /etc/init.d/networking restart” or simply reboot your system.
Additional Resources
In case you’re struggling to get the driver installed, you can visit the D-Link website at http://www.dlink.com.tw for potential driver solutions. It’s worth noting that some users have reported mixed success with this approach, so it might be a good idea to try it out and see if it works for you.
By following these steps and ensuring that your network settings are correctly configured, you should be able to get your Legend dfe-530tx PCI Fast Ethernet Adapter working smoothly in both Windows Server 2000 and Linux environments.